Hydraulic press machine factory right now? Synchronization system: The machine consists of a mechanical synchronization mechanism composed of torsion shats, wingarms, jont bearing, ec, with simple structure, stable ano reliable performance, and high synchronization accuracy. The mechanical stop is adjusted by the motor, and the numerical control system controls the value; Stopper mechanism: The stopper is driven by a motor, and the two screw rods are driven to move synchronously through a chain operation. The numerical controlsystem controls the size of the stopper. Discover even more info at hydraulic press machine.
Even if there are shelves full of molds, don’t assume that these molds are suitable for the newly purchased machine. The wear of each mold must be checked by measuring the length from the front end of the punch to the shoulder and the length between the shoulder of the female mold. For conventional ols, the deviation per foot should be about t0.001 inches, and the total length deviation should not be greater than t0.005 inches. As for the precision grinding mld, the accuracy per foot should be ±0.0004 inches, and the total accuracy should not be greater than ±0.002 inches. It is best to use fine grinding molds for CNC bending machines, and conventional molds for manual bending machines.
We can provide installation service for all the sold out machines at customer factory. Small machines can be shipped assembled and some big machines must be shipped disassembled. That is why we provide installation service to our customer. Yingxin World Press Machine Company has exporting center in Shanghai with professional team to follow up logistic and document process, which also saves a lot of time in middle process. More than 65 years experiences focusing on producing power press machines.
As far as free bending is concerned, punch and die are procese at 85 or les (saler i better). When using this set of molds, pay attention to the ga beteen the male mold and the female mold at the bottom of the stroke, and the excessive bending that is sufficient to compensate for the springback and keep the material at about 90°. Generally, the springback angle of the free bending die on the new bending machine is s2, and the bending radis is equa to 0.156 times the opening distance of the die. For the bending of bottomed concave molds, the mold angle is generally 86 ~ 90°. At the bottom of the stroke, there should be a gap slightly larger than the thickness of the material between the male and female molds. The forming angle is improved because the bottomed die has a larger bending tonnage (about 4 times that of free bending), which reduces the stress that usually causes springback in the bending radius.
The reason for this is the significantly lower modulus of elasticity of aluminum compared to stel. However, i ore to realise reaterdegrees o defration, sale straightenig rolls must be used. With high-strength steels, on the other hand, a conflict of objectives arises. On the one hand, their high yield strengths require enormous forming forces and torques; on the other hand, small straightening rll diameters are als ned here to ahie asufficent egeo p lstificaton.The straightening o both aluminum and high-strength steels therefore requires a forming geometry adapted to the respective product. This is essentially determined by the number, diameter and spacing of the straightening rolls. See even more info on pressmachine-world.com.