Best splash resistance tester manufacturer? Universal testing machine (also known as tensile testing machine) that performs tensile, compression, flexure, peel, tear, shear, friction, and other types of mechanical testing in accordance with ASTM, ISO, and other industry standards. GESTER Abrasion Tester Professional manufacturer, providing a full range of solutions, Martindale Abrasion Tester in line with ASTM, ISO and other standard requirements, factory direct sales. Find even more info at splash resistance tester.
This bursting strength tester use pneumatic method, meet multinational standards and equipped with several changeable test clamp. The simple interface touching screen controller is easy and simple to handle. The specimen was clamped firmly by the pneumatic force which can also save effort. The test cover was made up of high-transparent glass with LED light inside which can observe the specimen easily. The Bursting Strength Testing Machine can induct the burst automatically which is much more sensitive and reliable. The bursting distension can go up to 75mm.
Correct use of computerized universal testing machine: When the electronic stepless speed regulation adjusts the lifting speed, it cannot be operated too fast. Before using the 50KN power machine, pay attention to check the tightening of the clamp tightening screws. When lifting the lower clamp, the movement should be stable, avoid collision, and often check the tightness of the clamp screw. When replacing the test fixture, pay attention to cooperate to prevent bruises.
ASTM D4060 Taber Abrasion Testing: Taber rotary type abrasion tester is a specification that determines the “Abrasion Resistance of Organic Coatings by the Taber Abraser.” Although written for organic coatings, the same method applies to inorganic coatings. At the conclusion of testing the sample(s) are then re-weighed. The wear index is then calculated by taking the average mass loss per 1,000 cycles per section 12 of ASTM D4060. Assured Testing Services has multiple taber abrasion machines that meet the ASTM D4060 standard. One of our machines is shown with an exposed sample on this page.
Equip with procedure time counter, digital temperature controller, auto temperature & time control, it has alarm hint while experiment ending.Can customize cup compound mode according to customers requirements. Samples Preparation: Place the samples and multi-fiber adjacent fabric under the constant temperature and humidity (temperature: 21±1℃, humidity: 65%±3%) for 4 hours. Cut 40mm*100mm specimen and multi-fiber adjacent fabric, and suture the specimen and multi-fiber adjacent fabric face to face along one short side. Read extra info on https://www.gesterinstruments.com/.